Fuel Filter Cross Reference
Mappa del sito

Mappa del sito

Nuovi prodotti


Maintenance knowledge about fuel water separator

Maintenance knowledge about fuel water separator

One: start inspection and preparation 1: Before using the water separator equipment, the driver's consent should be obtained. 2: Check the line installation of the fuel water separator, whether the steering of the supporting pump is normal 3: Water is supplied to the fuel water separator, and the top air valve is opened to allow air to escape. 4: Check the oil and water separation in the marrow water inlet and outlet system without any leakage Two: precautions during operation 1: Adjust the drain valve opening degree and keep the pressure inside the separator to facilitate the elimination of the oil in the separator. 2: Observe whether the gauges such as pressure gauges and thermometers are normal. 3: Observe the working condition of the treated drainage water quality and oil concentration alarm 4: After the discharge is over, it should continue to be poured into clean water for 15 minutes to clean the separator. 5: Close the inlet and outlet after the pump is stopped, avoid the loss of clean water in the cylinder, reduce the oxidation and corrosion of the inner wall. 6: Each time the fuel water separator is used for discharge, it should be recorded in the oil beauty record book. Three: maintenance 1: Regularly clean the filter, open the bottom of the separator to vent, and remove the sediment deposited in the lower part, impurities 2: Clean the internal separation components of the separator in time, and avoid cleaning the inner wall and components of the separator with a cleaning agent. 3: When a fault occurs, the cause should be identified and the failed coalescing component should be replaced in time.

in linea


chatta adesso Per favore clicca qui per la richiesta
Se hai domande o suggerimenti, ti preghiamo di lasciare un messaggio, ti risponderemo al più presto!